3 Common Problems Caused in Riveting

Partial riveting

1.Check whether the tip of gun bends, if bend, please change it.

2.You'd better to pay attention to keep the rivet head flange holding grip with plate when riveting.

3.Please try not to empty riveting.

Screws pass fail

1.Operational reasons: Skilled operators are needed to use manual gun or pneumatic gun. It's important for operators to control the strength, for excessive strength can cause tooth pattern damage.

2.Hydraulic riveting gun needs to adjust the stroke, which depends on the thickness of plate, as too large stroke could result in tooth pattern damage as well.

Riveting is not tight

1.Check the air pressure indicator is between 6-8, if not, please adjusted.

2.Hydraulic riveting gun needs to adjust the stroke according to the thickness of plate. This situation maybe caused by small stroke, please turn to a bigger stroke.

3.Check if the gun damages.